2012 hottest IP65 led wall washer manufacturer

Product Features:

1. The controller and the lamp body are separated, thus the heat on the lamp body can be reduced effectively and also LED lifespan is increased.

2. Super-speed radiating structure design is applied in lamp body. On the back of lamp body, there are numbers of radiating wires. Besides, cross-ventilated design is applied in the plugs on each end. So comparing to common lamps, its radiating efficiency is 30% higher.

3. The appearance design is elaborate and fashionable, suitable for the projection lighting or bridge and historic building. Waterproof, with double-layer waterproof structure, moisture-proof.

4. The seal ring is made of high-quality imported rubber. Lamp panel and light tube are fixed by heat-conducting transparent silicon resin.

5. Bracket is adjustable. Easy, convenient and fast installation.

Technical parameters:

• LED chip: Taiwan Epistar or CREE
• Single LED power: 3W
• LED quantity: 18Pcs
• System power: 54W
• LED color: red, yellow, blue, white, warm white
• Beam angle: 15°, 25°, 40°, 60°
• Input voltage: DC24V & AC220V  50~60Hz
• Protection level: IP65
• Environment temperature: -20°C~+45°C
• LED drive mode: 350mA constant current drive
• Control mode: DMX512 control
• Color effect: Monochromatic light cast, full color, chasing, water flowing, 256 grey
• Lifespan: 30000hours
• N.W: 3.6kg
• Color temperature: 2000-5000K

Beam angle:

Where to use:

Suitable for local lighting, accent lighting and flood lighting of bridges, building or gym, etc.

Material:

• Lamp body is made of stretched aluminum. Anodic oxidation on surface.
• Transparent toughened glass.
• Die-cast aluminum plugs on both ends.

Light distribution curve chart:

Structure and measurement chart:

System connection diagram:

Installed effect: